Reasons for Bowflex Treadmill Belt Slipping
- Incorrect Tension: The treadmill belt might not be tensioned properly. If it's too loose, it can slip during use.
- Wear and Tear: Over time, the belt or the deck beneath it can become worn out, impairing proper traction.
- Improper Lubrication: Lack of lubrication or the use of incorrect lubricants can cause the belt to slip by increasing friction between the belt and deck.
- Misalignment: If the belt isn’t properly aligned, it can drift to one side and slip off track.
How to Fix the Slipping Belt
- Check Belt Tension:
- Locate the tension bolts at the end of the treadmill.
<li>Use an Allen wrench to tighten the bolts slightly, turning each one equally. Make small adjustments and check the tension frequently.</li>
<li>The belt is properly tensioned when you can lift it about 2 to 3 inches from the deck at the midpoint.</li>
</ul>
- Inspect for Wear:
- Look at the belt and deck for signs of wear. If the belt is frayed or the deck is damaged, consider replacing them.
<li>Regular maintenance will help you spot wear early, allowing you to replace parts before they cause slippage.</li>
</ul>
- Apply Proper Lubrication:
- Turn off and unplug the treadmill.
<li>Lift the belt slightly and apply silicone-based lubricant to the underside of the belt.</li>
<li>Spread the lubricant evenly and then run the treadmill for a few minutes to ensure it is thoroughly distributed.</li>
</ul>
- Ensure Proper Alignment:
- Align the belt by adjusting the rear roller. Use an Allen wrench to turn the bolts either clockwise or counterclockwise until the belt runs centered.
<li>Make small adjustments and run the treadmill to assess alignment. Repeat if necessary.</li>
</ul>
